SilverCrest SMS 300 B2 Mode D'emploi Et Consignes De Sécurité page 14

Cleaning the HEPA dust filter
After you have removed the HEPA dust filter
place the HEPA dust filter
knock the HEPA dust filter
Wait until the dust in the plastic bag has settled and then remove the
HEPA dust filter
dispose of it afterwards.
If necessary, you can rinse out the HEPA dust filter
lukewarm water. Allow the HEPA dust filter
After cleaning, replace the HEPA dust filter
that it is firmly seated.
Replace the empty dust container
the recess for the dust container
NOTE
► New HEPA dust filters
(see section Ordering spare parts).
Cleaning the UV-C lamp
WARNING! RISK OF INJURY!
► The UV-C lamp
down sufficiently after use. Otherwise, there is a risk of burns.
Use a screwdriver to loosen the screw on the cover
and remove the cover
Wipe the UV-C lamp
NOTE
Be careful not to touch the UV-C lamp
Put on the cover
Changing the UV-C lamp
WARNING! RISK OF INJURY!
► The UV-C lamp
down sufficiently after use. Otherwise, there is risk of burns.
► The technical information data for the UV-C lamp
section Technical data.
Use a screwdriver to loosen the screw on the cover
and remove the cover
Pull the UV-C lamp
Insert a new UV-C lamp
Put on the cover
SMS 300 B2
4
in a plastic bag. Close the plastic bag and
4
out carefully.
4
from the plastic bag. Close the plastic bag again and
3
with the inserted HEPA dust filter
3
on the appliance.
4
can be reordered from the customer service
8
gets hot during use. Allow the UV-C lamp
e
.
8
with a dry duster.
e
and fix it again with the screw.
8
gets hot during use. Allow the UV-C lamp
e
.
8
out of the plug connections.
8
into the plug connections.
e
and fix it back in place with the screw.
4
from the dust container
4
with fresh cold or
4
to dry out completely.
4
in the dust container
e
of the UV-C lamp
8
with your fingers.
8
can be found in the
e
of the UV-C lamp
GB │ IE
3
,
3
so
4
in
8
to cool
8
8
to cool
8
│
11 ■