SilverCrest SMS 300 B2 Mode D'emploi Et Consignes De Sécurité page 12

1) Plug the power plug into a properly installed, easily accessible wall outlet.
2) Place the appliance flat on the surface to be cleaned.
3) To switch the appliance on, push the On/Off switch
appliance starts vacuuming.
4) Press the vibration button
shakes up the surface to be cleaned and the swirled up dust is sucked in
through the suction opening
on the UV-C lamp
5) Move the appliance evenly over the surface to be cleaned.
6) After vacuuming, push the On/Off switch
appliance.
7) Unplug the appliance from the mains socket.
Usage recommendations
Always clean mattresses from both sides.
New mattresses should be cleaned once a month. Older mattresses should
first be cleaned daily for one week. Afterwards, cleaning should take place
once a month.
The HEPA dust filter
on use, the UV-C lamp
about spare parts, please contact customer service (see section Service).
Cleaning
RISK OF ELECTRIC SHOCK!
► Before cleaning the appliance, disconnect the power plug from the power
socket. Otherwise, there is a risk of electrocution.
CAUTION! PROPERTY DAMAGE!
► Do not use abrasive, aggressive or chemical cleaning agents.
They can damage the surface and also lead to irreparable damage to the
appliance.
Clean the appliance only with a soft cloth lightly moistened with water.
Empty the dust container
The HEPA dust filter
the motor.
SMS 300 B2
w
to activate the vibration head
9
. Pressing the vibration button
8
.
4
should be changed every 12 –18 months depending
8
every 12 – 24 months. If you have any questions
3
after each use of the appliance.
4
must also be cleaned regularly to avoid overloading
2
forwards. The
7
. The vibration
w
also switches
2
back to switch off the
GB │ IE │
9 ■