Parkside 392452 2201 Instructions D'utilisation Et Consignes De Sécurité page 19

˜ Fixing and removing the
container lid
Fixing the container lid
– Place the container lid on the metal
container .
10 ] [
– Lock the container lid in place with the
latches .
11 ] [
Removing the container lid
– Undo the latches
– Lift the container lid off the metal
container .
10 ] [
˜ Operation
m WARNING! Risk of injury!
Before operation, read the instruction manual
u
of the motorised vacuum cleaner you want to
use with the product!
Do not vacuum incandescent materials . Even
u
material that looks as though it has cooled
off on the outside may still be very hot on the
inside . Hot extracted material could be set
alight again in the air current .
Hot ashes should not be purged with water,
u
as the sudden temperature difference can
cause ruptures to the chimney .
Wait at least 24 hours before vacuuming a
u
fireplace to make sure that the fire has gone
out and the ash has cooled down .
˜ Connecting the product with
a motorised vacuum cleaner
(not included)
Secure the container lid
container with the latches
10 ] [
For the following steps, you need a motorised
vacuum cleaner and the associated hose
(Fig . B):
– Attach the hose adapter that belongs to
the hose of the motorised vacuum cleaner
(not included) with the external vacuum
connector .
[ 2 ]
– Connect the other end of the hose to the
motorised vacuum cleaner .
:
1 ] [
:
1 ] [
.
11 ] [
to the metal
1 ] [
.
11 ] [
– The motorised vacuum cleaner now serves
as an external suction power source for the
product .
m WARNING! Follow the operation procedures,
including the illustrations of the motorised
vacuum cleaner's instruction manual .
˜ Emptying the metal container
Remove the container lid
container (see "Fixing and removing the
10 ] [
container lid") . Empty the metal container .
m WARNING!
Empty and clean the product before and
u
after use to avoid the collection of materials
that could pose a fire hazard in the vacuum
cleaner .
˜ Cleaning and replacing the
pleated filter
When the suction power of the product
decreases, clean the pleated filter
Removing the pleated filter
Fig . C
Remove the container lid
container (see „Fixing and removing the
[ 10 ]
container lid") .
Turn over the container lid
Hold the pleated filter
pleated filter in an anticlockwise direction .
Lift the pleated filter
mesh out of the product .
13 ] [
Take the pleated filter
mesh .
13 ] [
Cleaning the pleated filter
NOTE
Never clean the pleated filter
u
You would otherwise damage the pleated
filter .
Shake the pleated filter
pleated filter gently on the floor .
from the metal
1 ] [
.
[ 12 ]
from the metal
[ 1 ]
.
[ 1 ]
by the rim . Turn the
[ 12 ]
together with the wire
[ 12 ]
out of the wire
[ 12 ]
with water .
12 ] [
. If necessary, tap the
[ 12 ]
GB/IE 19