General Information; Safety Information - Hach ABS-2 Manuel D'utilisation

Specifications
Specifications are subject to change without notice.
Dimensions (W x L x H) 32.4 x 45.7 x 68.6 cm (12.75 x 18 x 27 in.)
Weight 20 kg (44 lb)
Installation category II
Pollution degree 2
Protection Class I
Sample flow rate 1–200 mL/min (user adjustable, fluid-viscosity
dependent)
Sample volume 5–100 mL (user adjustable, 5 mL increments)
Dead (Tare) volume 16 mL
Sample accuracy ±5% of selected volume
Repeatability ±1%
Fluid compatibility Fluids compatible with stainless steel, glass, Teflon
and Tygon
Operating pressure range Minimum: -20 PSI (-34 kPa) recommended
Maximum: 50 PSI (344.7 kPa)
Temperature Operating: 10 to 50 ºC (50 to 122 ºF)
Non-operating: -40 to +65 ºC (-40 to +149 ºF)
Maximum altitude Operating: 3000 m (9840 ft)
Non-operating: 15240 m (50000 ft)
Relative humidity 10 to 80% RH (non-condensing)
Host I/O RS232 (DB-25 female)
Certifications CE
™
Power requirements
Instrument
With optional pump

General information

In no event will the manufacturer be liable for direct, indirect, special,
incidental or consequential damages resulting from any defect or
omission in this manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without
notice or obligation. Revised editions are found on the manufacturer's
website.

Safety information

™
The manufacturer is not responsible for any damages due to misapplication or
misuse of this product including, without limitation, direct, incidental and
consequential damages, and disclaims such damages to the full extent permitted
under applicable law. The user is solely responsible to identify critical application
risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating
this equipment. Pay attention to all danger and caution statements.
Failure to do so could result in serious injury to the operator or damage
to the equipment.
Make sure that the protection provided by this equipment is not impaired.
Do not use or install this equipment in any manner other than that
specified in this manual.
100–230 VAC, 50/60 Hz, 0.5 A
115 VAC, 60 Hz, 4.5 A
100 VAC, 50 Hz, 4.5 A
230 VAC, 50 Hz, 1.9 A
N O T I C E
English 3