Product Overview - Hach ABS-2 Manuel D'utilisation

operate the equipment. This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user will be
required to correct the interference at their expense. The following
techniques can be used to reduce interference problems:
1. Disconnect the equipment from its power source to verify that it is or
is not the source of the interference.
2. If the equipment is connected to the same outlet as the device
experiencing interference, connect the equipment to a different
outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the
interference.
5. Try combinations of the above.

Product overview

The instrument sends and measures a specified volume of liquid sample
through a sensor. The instrument sends a start signal and a stop signal
to a counter as the sample moves through the sensor.
This instrument is part of a batch fluid analysis system. For details on
how to include the instrument in a specific application or system, refer to
the manuals for the peripheral equipment. Contact a technical
representative for compatibility or suitability questions.
Instrument connections
Figure 1 shows the main connections on the back of the instrument.
Figure 2 shows the layout and connections of components in the top of
the instrument.
Figure 1 Rear panel connections
1 Vent outlet
2 Pressure/vacuum vent
3 Pressure port
4 Vacuum port
5 Sample drain port
6 Pressure/vacuum pump AC outlet
7 Line power connection
8 AC fuse compartment
9 On/Off switch
10 Sampler communication port (to
counter)
11 Sensor cable port (to counter)
English 5