Publicité
Les langues disponibles
Les langues disponibles
PROGRAMMING ENTRY PANELS WITHOUT VA/01 OR A/01
Programming for the first time
>3''
>3''
PROG
<6''
<6''
a
a a
PROG
Programming the open-gate function
An operator control can be connected to the module auxiliary relay and/or an operator status to the door status input.
From applicable, preconfi gured internal receivers, the relay can be controlled using the open-gate command and/or the operator status
shown via the relevant LED on the internal receiver itself.
To confi gure the module with the open-gate function, enable the function on one of the connected internal receivers, by entering call
programming (see previous paragraph), and send an open-gate command from the internal receiver (press and hold the "key" button)
as an alternative to or in addition to associating the call button. The open-gate LED lights up on this internal receiver to indicate that the
function has also been enabled on the module.
☞
If the module is programmed with the open-gate function, the "door contact input" terminal will function exclusively as
an operator status indicator.
☞
This function is available from version 1.03.000 of the module software.
☞
You can force the switch from one programming mode to another by pressing the PROG button on the module unit for 3
seconds and releasing within 6 seconds. If you force the switch to call programming from button programming, the button
units which have not been programmed will be confi gured to 8 calls. If the basic module is not programmed, calls are not
confi gured.
Entering programming mode
Press and hold the PROG button
within 6 seconds.
The LEDs
and
.
a
a
a
a
>3''
on the entry panel for at least 3 seconds and release
and the button LEDs fl ash to show the buttons are being programmed
Programming buttons
Press the fi rst call button on each module
stops fl ashing and remains on. Repeat for all the other call
devices.
☞
For the basic module (no call buttons)
not need to press the buttons that are shown as fl ashing in
a a .
fi gure
Once programming is complete, you are automatically taken to
"programming calls".
Programming calls
The LED
fl ashes. Lift the internal receiver handset (if present)
and press the door lock release
On the entry panel, press the call button to be associated with
the internal receiver
b b . End the call and repeat programming for all of
been saved
the other internal receivers.
a a
or
and AUX2
a a . A beep confi rms that the setting has
. The module
a a , you do
buttons
.
b b
Publicité
