Publicité
Les langues disponibles
Les langues disponibles
<1''
<1''
PROG
a a
0
100 °
6
82 °
1÷9
4
72 °
54 °
8
Adjusting the brightness level of the light on the entry panel
While programming calls
Press the "auto-connection
panel for which you want to adjust the brightness level. Use a previously assigned call button to increase/
decrease brightness
Reprogramming
When reprogramming a system which has already been programmed, you are taken directly to call programming. To access button
reprogramming, follow the process for forcing the mode switch described above.
If you add, replace or remove an entry panel, you must follow the "programming buttons" procedure so that the system recognises the
changes.
Programming an intercommunicating group
☞
Leave the function disabled if the entry panel is connected to a VA/01, A/01 or VSE/301.01.
Before programming an intercommunicating group, enable the intercommunicating function. This function is disabled by default.
Enabling/disabling
Press the PROG button on the entry panel and hold for at least 20 seconds
The red
and yellow
LEDs fl ash quickly for 3 seconds
☞
If the intercommunicating function is disabled, follow this procedure to enable it, and vice versa.
The yellow LED
comes on for 2 seconds to show the function has been enabled, or the red LED
the function has been disabled.
☞
Program the intercommunicating group after assigning calls to all indoor receivers.
b b
c c
Programming the entry panel video camera
While programming the calls, the video camera's fi eld of view can be adjusted from any
receiver. To do this, lift the handset (where present) and press the "auto-connection
button
. From the default confi guration, scroll through the subsequent confi gurations
pressing the AUX1 button or go back to the previous confi gurations by pressing the
AUX2 button
2
7
5
1
9
3
a a , the brightness level of the entry panel light can be adjusted from any receiver.
" button on the internal receiver
.
.
Exiting programming
Press the PROG button briefl y
switch off .
Adjusting the brightness and colour of the module
backlight
During call programming
and colour of the module backlight. Press the left call button to
select white
②, and the right call button to select blue
Press the same button repeatedly to select one of the fi ve
brightness levels (off , 25%, 50%, 75%, 100%).
. Settings are saved automatically.
b b to activate the video camera on the entry
.
. The LEDs on the entry panel
①, you can adjust the brightness
a a
comes on for 2 seconds to show
③.
"
b b
Publicité
