Publicité
Les langues disponibles
Les langues disponibles
a
a
0
100 °
82 °
1÷9
72 °
54 °
Reprogramming
When reprogramming a system which has already been programmed, you are taken directly to call programming. To access button
reprogramming, follow the process for forcing the mode switch described above.
If you add, replace or remove an entry panel, you must follow the "programming buttons" procedure so that the system recognises the
changes.
AUTOMATIC DOOR RELEASE function
For internal receivers that support the AUTOMATIC DOOR RELEASE function only.
This function is used to open the entrance automatically when there is a call from the entry panel. No communication is activated and
the call ends automatically.
☞
Follow the instructions in the internal receiver manual.
RESTORING FACTORY SETTINGS
To restore the entry panel to the default settings (including the terminal functions
the two call buttons on the unit and power the device.
After 5 seconds the entry panel restarts.
☞
if the entry panel does not restart, it has not been restored to factory settings.
b b
Programming the entry panel video camera
While programming the calls, the video camera's fi eld of view can be adjusted from any
receiver. To do this, lift the handset (where present) and press the "auto-connection
button
pressing the AUX1 button or go back to the previous confi gurations by pressing the
AUX2 button
2
6
7
4
1
5
9
8
3
Adjusting the brightness level of the light on the entry panel
While programming calls
adjusted from any receiver. Press the "auto-connection
b b to activate the video camera on the entry panel for which you want to adjust the
brightness level. Use a previously assigned call button to increase/decrease brightness
of the light
Adjusting the brightness and colour of the module
backlight
During call programming
and colour of the unit backlight. Press the left call button to select
c c
b b , and the right call button to select blue
white
Press the same button repeatedly to select one of the fi ve
brightness levels (off , 25%, 50%, 75%, 100%).
. From the default confi guration, scroll through the subsequent confi gurations
. Settings are saved automatically.
a a , the brightness level of the entry panel light can be
.
a a , you can control the brightness
a a
" button on the internal receiver
,
), remove the power supply, press and hold
c c .
"
b b
Publicité
