ISE SY-T2710 Manuel D'instructions page 21

If the belt has drifted to the right, unplug the safety lock and
turn the power off, then turn the right adjusting bolt 1/4 turn
clockwise, after that insert the safety lock and turn the
power on, make the treadmill running, observe the running belt
deviate condition. Repeat above steps until the running belt be
placed in the middle.
Once t he treadmill belt swerving to the left, unplug the safety
lock, turn off the power, then with the left adjusting bolt clock-
wise rotation 1 / 4 laps, and turn on the safety lock and power
on, make treadmill running, checking the deviation of the tread-
mill belt. Repeat the above steps until the belt centered.
The treadmill belt will gradually relax after above steps or after
a period of time using, unplug the safety lock, and turn off the
power, with the two adjusting bolt clockwise rotation 1 / 4 laps,
and turn on the safety lock and power to make treadmill run-
ning, then standing on the belt to confirm the tightness. Repeat
the above steps until the belt become tightness
Please be assured that the box of this product is recycling, the rest of the packaging can be trashed.
In case the product contains batteries, do not trash directly.
This device concerned has been manufactured under an EU
Declaration of Conformity and compliance with all relevant EU
Directives, including CE,EN ISO 20957-1,EN 957-6.
Importer:
SAS ISE
1 Chemin d'Armancourt
60200 Compiègne France
TEL : +33 3 44 76 21 66
PORT : +33 6 32 91 85 26
contact@isefit.com
www.isefit.com
9
Figure A
Figure B
EN
Figure C