Publicité
Les langues disponibles
Les langues disponibles
"Stop" button - Stop the motor
1. When the meter is running, press "Stop" to stop the motor running.
2. After the motor stops moving completely, all motion data are cleared to the initial state.
"Program" button - Auto program selection
1. When the meter is in standby mode, press "Program" to enter the automatic program set-
ting.
2. Operation flow: program setting - return to initial standby state.
"Mode" button - Countdown mode selection
1. When the meter is in standby mode, Press "Mode" to enter the countdown mode setting.
2. Operation flow: program setting - return to initial standby state. time. distance. calorie
countdown.
"Speed+/-" button - Adjust speed when running, adjust parameter value when set-
ting
1. When the meter is in standby mode, can adjust the running speed value.
2. In the parameter setting state, parameter value can be adjusted.
"Speed Shortcuts" - Directly select speed value when running
Press "Speed Shortcuts" to directly select the corresponding speed value.
Safety lock function
Pull up the safety lock, "E7" will be displayed in the meter and accompanied by beep warning.
Put back the safety lock, the meter will rework in 2 seconds, and all motion data is cleared.
Button function and operation
"Start" button and "Stop" button - When the treadmill is in standby mode, press "START", the
speed is "1.0", then the motor start running. When the treadmill is running, press "Stop", all
motion data is cleared, it turns to Manual mode and the motor stop running。
"Speed+/-" button - Adjust speed when running, adjust parameter value when setting
When the meter is in standby mode, can adjust the running speed value, 1km/Per.
You can adjust to the speed that you want at any time.
"Program" button
When the meter is in standby mode, press "Program" , from Manual mode 1KM to enter the
automatic program setting P1-P12 .
The manual mode is the system default operation mode, the default mode of the manual mode
is 1.0KM/H, the maximum speed is 10KM/H. After selecting the program mode, press" start"
button to start the treadmill. The treadmill automatically adjusts the speed according to the
set program.
Select Program
The system default running time is 10 minus, select program then select running time,
The program segment of each program is divided into 10 segments, and the running time of
each program block is same.
All motion data is cleared when it stop running .
P1-P12 Program motion map is below, shown in Schedule 1
5
EN
Publicité
