ISE SY-T2710 Manuel D'instructions page 19

Error message of meter and troubleshooting
Code Error Description
The order that is sent to the
controller by the meter and the
E1
message that is fed back to the
meter by the controller are
blocked.
The controller does not detect
E2
the voltage on the motor cord.
The controller does not detect
E3
the feedback signal of speed
when the motor is working.
The current exceeds rated
current when the motor is
E5
working.
The current is lower than rated
E6 current when the motor is
working.
The meter does not detect the
E7
signal from the safety key.
Troubleshooting
Check the joint of wire connecting the meter and con-
troller to see whether it is loose. Check the wire to see
whether it is damaged. Make sure that the connection
sequence of the wire is correct.
1.Check the joint of wire connecting the meter and
controller to see whether it is loose.
2.After the fault condition is maintained for about 10
seconds, it enters the standby state and can be restart-
ed. Possible reason：no speed sensing signal detected
for 3 seconds, check if the sensor plug is not plugged in
or damaged, plug it in or replace the sensor.
3.If it returns to normal after shutdown, it can enter the
standby state and start normally.
Check if the motor wire is connected and reconnect the
motor wire. Check if the controller is intact and replace
the controller.
1.After the fault condition is maintained for about 10
seconds, it enters the standby state and can be restart-
ed.
2.Some part of the treadmill is stuck, check the tread-
mill and adjust it to re-run.
Check the motor for sound or burnt smell, change
motor. Check the controller for burnt smell and replace
the controller. Check if the power supply voltage is
correct, use the correct voltage.
Check if the power supply voltage is lower than 50% of
the normal voltage, please use the correct voltage and
start over. Check the controller for burnt smell and
replace the controller. Check if the motor wire is con-
nected and reconnect the motor wire.
Check the magnetron to see if it is damaged, or, in the
correct position. Make sure that the magnet is well
placed.
7
EN