Télécharger Imprimer la page

Samsung Laundry Combo WD53DBA9 H Serie Manuel D'utilisation page 84

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Information codes
If there is any problem, check the information message on the LCD screen and follow the on-screen
instructions.
Problem
Check drainage
Check water supply
Please connect the
hot/cold water hose
connection correctly
Incorrect button state
Open the door and evenly
distribute the load
Waterproof items
detected
Door is open
Close the washer door and
try again
84
English
Untitled-15 84
Untitled-15 84
Code
• The Laundry Combo isn't draining properly.
• Clean the drain filter, then tap Start to restart the Laundry
Combo. Or, turn it off and on again after 2-3 minutes, then
try again.
5C
NOTE
If you perform the Condenser Cleaning function without
connecting the water supply hose, you may see the 5C code
on the LCD display. In this case, please check the drainage
and water supply status.
• Water isn't being supplied properly.
• Check the faucets, then tap Start to restart the Laundry
4C
Combo. Or, turn it on and off again after 2-3 minutes, then
try again.
• The water is too hot. Some fabrics need to be protected.
• Check if the water supply hoses are properly connected,
4C2
then tap Start to restart the Laundry Combo. Or, turn it off
and on again after 2-3 minutes and try again.
• A button on the Laundry Combo is still pressed in.
BC2
• Turn off the Laundry Combo, then turn it on again after
2-3 minutes and try again.
• The spinning process is not performing properly because
there is not enough laundry or the load is unbalanced.
UB
-
Add more laundry or redistribute the items, then tap
Start to restart the washer. Or, turn off the product and
turn it back on after 2-3 minutes, then try again.
• Your laundry contains waterproof items.
• Remove those items, then tap Start to restart the Laundry
UB1
Combo. Or, turn it off and on again after 2-3 minutes, then
try again.
DC
• The door is open. Close it and try again.
• Auto Open Door isn't working properly.
• If you turn off the power, the door will open. To use
DC6
Auto Open Door, turn off Lock and Smart control in
SmartThings.
Action
2024-07-11
2024-07-11
3:47:50
3:47:50

Publicité

loading