Publicité
Les langues disponibles
Les langues disponibles
Self Clean+
Certain usage and environmental conditions may result in some residue build-up or odor in the drum. To
prevent this build-up or odor and keep the drum fresh and clean, perform the Self Clean+ cycle at least
once a month or every 40 cycles. Perform the recommended procedure below when using the Self Clean+
cycle.
1. Tap
.
2. On the cycle screen, select Product Care > Self Clean+.
3. Tap Clean now.
CAUTION
If there is chlorine bleach left in the drum for an extended period of time, rust can occur.
NOTE
• The water temperature for Self Clean+ is defaulted to Extra Hot. This temperature cannot be changed.
• In the case where residue is present in the drum, add liquid chlorine bleach to the MAX level line in
the Manual bleach compartment before starting the Self Clean+ cycle. Do not add the liquid chlorine
bleach to the other compartments (This is only the case for Self Clean+ cycle).
• Do not exceed the max line. Do not use or mix any other detergent or chemicals during the Self Clean+
cycle. If necessary, run a Rinse+Spin cycle after the Self Clean+ cycle has completed to help remove any
remaining residue.
Self Clean+ reminder
• After every 40 cycles, the Laundry Combo displays the "Time to run Self Clean+ ▷ Press Clean now to
start the Product care cycle." message for an hour to alert you to run the Self Clean+ cycle.
• It is recommended to run the cycle regularly for hygienic purposes.
• You will see the Self Clean+ alert message when the Laundry Combo completes a cycle. If you open the
door, the message disappears, and the display shows the Self Clean+ cycle setting screen automatically.
At this time, the LCD panel displays the recommended drying cycle.
• The reminder will appear on the LCD panel for 5 additional consecutive cycles before turning off. The
next reminder will not appear until another 40 cycles have been completed.
Untitled-15 63
Untitled-15 63
English 63
2024-07-11
2024-07-11
3:47:46
3:47:46
Publicité
