Publicité
Les langues disponibles
Les langues disponibles
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button 0 repeatedly until the
programme indicator for the programme you
want to use starts to flash.
–
PUREED SOUP
soups
–
CHUNKY SOUP
7) Press the START/STOP button u. The appli-
ance beeps. The programme indicator of the
selected programme lights up permanently.
Preparation of the soup now takes place automat-
ically. The appliance heats and mixes at regular
intervals.
NOTE
►
You can stop the preparation process at any
time by pressing the START/STOP button u
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete,
the appliance will stop automatically. The appli-
ance will beep and the relevant programme indica-
tor of the set programme flashes.
8) If you do not want to serve the soup immediately,
you can activate the keep-warm function: Use
the MODE button 0 to select the programme
KEEP WARM
STOP button u to start the programme.
After 60 minutes, the appliance stops automati-
cally. You can stop the keep-warm process at
any time by pressing and holding the START/
STOP button u.
9) Remove the plug from the mains power socket
and the connector 3 from the built-in plug 4.
10) Remove the lid 8 carefully from the blender
jug 5 and place it to one side.
WARNING! RISK OF INJURY!
Be careful when opening the lid 8.
►
Hot vapour can escape! We recommend the
use of oven gloves.
SMK 1000 B2
q for creamy, pureed
w for chunky soups.
z and press the START/
You can now serve the soup in bowls or a soup
terrine.
NOTE
►
Clean the appliance after every use (see
section "Cleaning and care"). Otherwise resi-
dues from the previous cooking process that
may be left on the bottom of the container
could burn.
Preparing compote
1) Cut the fruit/vegetables into pieces of around
2 cm and place these in the blender jug 5.
2) Fill the blender jug 5 up to no more than the
MAX - 1600 ml marking with water or other
liquids. Always fill up to at least the MIN -
1300 ml marking!
3) Place the lid 8 on the blender jug 5. Ensure
that the contact plug 1 in the lid 8 fits cor-
rectly in the safety socket 2.
4) Insert the connector 3 into the built-in plug 4
on the appliance.
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button 0 repeatedly until the
COMPOTE programme indicator
to flash.
7) Press the START/STOP button u. You will hear
a beep and the COMPOTE programme indica-
e flashes.
tor
Preparation of the compote now takes place auto-
matically. The programme runs for 13 minutes.
NOTE
►
You can stop the preparation process at any
time by pressing the START/STOP button u
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete, the
appliance will stop automatically. You will hear
a beep and the COMPOTE indicator light
flashes.
e starts
e
GB │ IE
│
21
■
Publicité
