SilverCrest SHBS 3.7 C2 Mode D'emploi page 50

Nose/ear hair trimmer attachment
• Remove the nose/ear hair trimmer attachment 12. Rinse it
with water and let it dry completely before using it again.
Shaving attachment
WARNING!
Do not detach the shaving foil from the shaving foil frame,
and do not clean it using the cleaning brush 17.
NOTE: from time to time, oil the cutting blade with a few drops
of acid-free oil (e.g. sewing machine oil). Attach the shaving at-
tachment to the hair and beard trimmer 5 and let it run for a few
seconds without using it. Using a soft cloth, wipe off the surplus
oil, if necessary.
1. Remove the shaving attachment 3.
2. Press the button on the side of the shaving attachment and
remove the shaving foil frame. While removing the shaving
foil frame, only hold it at the side and do not press against
the shaving foil.
3. Clean the cutting blade using the included cleaning
brush 17.
4. Clean the shaving foil in the shaving foil frame under run-
ning water and allow it to dry completely before putting it
back on the shaving attachment 3.
5. Put the shaving foil frame back onto the shaving attach-
ment 3. While attaching the frame, make sure that the fasten-
ing tabs on the shaving foil frame fit into the appropriate
recesses on the shaving attachment, and press the shaving foil
frame gently downwards until it audibly locks into place.
48
GB
3
12