SilverCrest SHBS 3.7 C2 Mode D'emploi page 47

6.5 Trimming a beard
Beard trimmer attachment
NOTE: please note that the cutting lengths will only be achieved
if the switch for cutting length fine tuning 6 is at position 1 and
the hair and beard trimmer 5 is held at a right angle to the skin
surface.
• Comb the beard in the direction that it grows.
• Trim the beard downwards from ear to chin. First trim one
side, then the other.
• Comb attachment 1
Figure C: adjust the cutting length with the slider according
to the desired hair length and read off the cutting length us-
ing the marking on the side of the comb attachment 1 (3, 4,
5, 6 mm). Now, shorten your beard step-by-step.
• Use the beard trimmer attachment 14 without a comb attach-
ment 1, to cut the beard very short or to cut a moustache
and hairline.
• Using the switch for cutting length fine tuning 6 the cutting
length can be slightly varied with three levels (1: 0.8 mm /
2: 1.3 mm / 3: 1.8 mm).
• To trim your moustache, first comb it straight downwards.
Then use either the beard trimmer attachment 14 or the pre-
cision trimmer attachment 4. Start at the centre above the
mouth and trim first one side, then the other.
14
45
GB