Publicité
Les langues disponibles
Les langues disponibles
Sawing flush to edges:
Using flexible saw blades with a suitable cor-
responding length, you can saw off protruding
workpieces such as pipes flush to the wall .
Proceed as follows:
1 . Place the saw blade
2 . Bend it by applying lateral pressure to the sabre
saw so that the footplate
the wall .
3 . Switch the appliance on as described and
saw off the work piece by applying constant
pressure .
Plunge sawing:
CAUTION! RISK OF KICKBACK!
■
Plunge cuts may only be made in soft
materials (wood or similar) .
Proceed as follows:
1 . Place the sabre saw with the lower edge of the
footplate
onto the workpiece . Switch the
appliance on .
2 . Tilt the sabre saw forwards and plunge the saw
blade
into the workpiece .
3 . Position the sabre saw vertically and continue
sawing along the cutting line .
PSSA 20-Li A1
directly against the wall .
makes contact with
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always switch the appliance off and
remove the battery before carrying
out any work on the appliance.
■
The appliance must always be kept clean, dry
and free from oil or grease .
■
Use a soft, dry cloth to clean the housing .
■
Replace the saw blade as soon as its teeth are
blunt and proper sawing is therefore no longer
possible .
■
Keep the appliance and ventilation slits clean at
all times . If the ventilation slits are blocked, there
is a risk of overheating and/or the appliance
being damaged .
■
Always clean the appliance after completion
of work .
■
Never permit liquids to enter inside the appli-
ance . Use a cloth to clean the housing . Never
use petrol, solvents or cleansers which can
damage plastic .
■
If necessary, clean the saw blade mount with a
brush or compressed air .
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
GB │ IE
│
23
■
Publicité
