Publicité
Les langues disponibles
Les langues disponibles
Wear hearing protection!
Vibration values (vector total of three directions)
determined in accordance with EN 60745:
Total vibration value:
Sawing chipboard: a
h,B
Uncertainty: K = 1 .5 m/s
Sawing of timber beams: a
Uncertainty: K = 1 .5 m/s
NOTE
►
The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons . The
specified vibration emission value can also
be used to make an initial exposure estimate .
WARNING!
►
The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions in
some cases . Regular use of the power tool in
this way may cause the user to underestimate
the vibration . Try to keep the vibration loads
as low as possible . Measures to reduce the
vibration load are, e .g . wearing gloves and
limiting the working time . Wherein all states of
operation must be included (e .g . times when
the power tool is switched off and times where
the power tool is switched on but running
without load) .
PSSA 20-Li A1
= 11 .4 m/s
2
2
= 9 .6 m/s
2
h,WB
2
General Power Tool
Safety Warnings
WARNING!
►
Read all safety warnings and all instructions .
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .
1 . Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
2 . Electrical safety
a) Power tool plugs must match the outlet.
Never modify the plug in any way.
Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock .
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded .
GB │ IE
│
17
■
Publicité
