Publicité
Les langues disponibles
Les langues disponibles
Adjusting the footplate
RISK OF INJURY!
►
Always switch the appliance off and remove
the battery before carrying out any work on
the appliance .
♦
Adjust the footplate
depth .
♦
To do so, undo the locking lever
the footplate
to the corresponding position .
♦
Lock this position by closing the locking lever
Adjusting the pendulum stroke
♦
You can use the pendulum stroke switch
adjust the pendular movement of the saw blade
. You can achieve fine, clean-cut edges with-
out pendulum movement (setting "0") . Deacti-
vate pendulum movement when working on thin
workpieces . You can achieve an increasingly
fast work rate if the pendulum stroke is activated
(setting "I") .
Use
Switching on and off
Switching on:
♦
First press the safety lock-out
ON/OFF switch
safety lock-out
.
Switching off:
♦
Release the ON/OFF switch
■
22
│
GB │ IE
according to the cutting
and move
and then the
. Afterwards, release the
.
Adjusting the rotational speed
Press the ON/OFF switch
Increasing the pressure increases the speed .
NOTE
►
The integrated motor brake ensures rapid
stoppage .
Guiding the sabre blade safely
To adapt to the workpiece and for safe placement,
the footplate
.
in contact with the workpiece when the appliance
is running .
Practical advice on sawing
to
♦
Check the material to be worked to make sure
that all foreign objects have been removed,
e .g . nails, screws, etc .
♦
Ensure that the ventilation slits
covered .
♦
Switch the appliance on before moving it
towards the material to be worked .
♦
Switch the appliance off immediately if the saw
blade
jams .
Open up the sawn gap using a suitable tool
and pull out the sabre saw .
■
Use the appropriate saw blade
rate for the material to be worked .
■
Saw blades optimised for your sabre saw are
available from retail stores in different lengths
for various purposes .
■
Saw the material at a constant speed .
lightly for a low speed .
can be swivelled . It must always be
are not
PSSA 20-Li A1
and stroke
Publicité
