Publicité
Les langues disponibles
Les langues disponibles
♦
Undo the clamping nut
mounting spanner
♦
Place the rough grinding or cutting disc with the
label side towards the appliance on the attach-
ment flange
.
♦
Then replace the clamping nut
ment spindle
with the raised side facing up.
With thin grinding discs (see fig. 1):
♦
The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
♦
Press the spindle locking button
motor.
♦
Tighten the clamping nut
mounting spanner
With thick grinding discs (see fig. 2):
Fig. 2
The collar of the clamping nut
so that the grinding disk can be fitted securely onto
the attachment spindle
♦
Lock the attachment spindle
♦
Tighten the clamping nut
rection using the two-hole mounting spanner
NOTE
►
If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
│
GB │ IE
■
30
using the two-hole
(see fig D).
on the attach-
faces upwards
≤ 3,2 mm
to lock the
using the two-hole
.
> 3,2 mm
faces downwards
.
.
in a clockwise di-
♦
For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦
Check whether all the fastening elements are
correctly fitted.
♦
Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
Operation
Switching on and off
Check the attached tool before use to ensure that
12
all fastening elements are correctly fitted.
NOTE
►
Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
Switching on:
♦
First, press the ON/OFF switch
so that you can then press it forwards.
Switching off:
♦
Let go of the ON/OFF switch
Switching to continuous operation:
♦
First, press the ON/OFF switch
so that you can then press it forwards. Then
press the ON/OFF switch
down until it engages.
Switching off continuous operation:
♦
Press the ON/OFF switch
downwards and release it.
.
to the right
.
to the right
forwards and
to the rear and
PWSA 20-Li B3
Publicité
