Publicité
Les langues disponibles
Les langues disponibles
♦
Place the rough grinding or cutting disc with the
label side towards the appliance on the mount-
ing flange .
♦
Then replace the clamping nut
ing spindle
with the raised side facing up.
With thin grinding discs (see fig. 1):
♦
The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
♦
Press the spindle locking button
gearbox.
♦
Tighten the clamping nut
assembly spanner .
With thick grinding discs (see fig. 2):
Fig. 2
The collar of the clamping nut
wards, so that the thick grinding wheel can be
securely mounted on the mounting spindle .
♦
Lock the mounting spindle .
♦
Tighten the clamping nut
rection using the two-hole assembly spanner .
NOTE
►
If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
│
GB │ IE
■
28
on the mount-
faces upwards
≤ 3,2 mm
12
to lock the
using the two-hole
> 3,2 mm
points down-
in a clockwise di-
♦
For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦
Check whether all fastening elements are
correctly fitted.
♦
Make sure that the arrow showing the direction
of rotation (if any) on the cutting or roughing
discs (including diamond cutting discs) and the
direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
are aligned.
Switching on and off
Check the inserted tool before use. It must be prop-
erly fitted, may not be damaged or damp, should
not have any cracks and must turn freely. Carry
out a 60-second test run. Do not use non-circular
or vibrating tools. Be aware of unusual noises and
sparks. Check afterwards whether all the fastening
elements are correctly fitted.
NOTE
►
Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
Switching on
♦
Activate the safety lock-out
♦
Then press the ON/OFF switch .
Switching off
♦
Press the ON/OFF switch
Setting the rotational speed
♦
Set the speed setting wheel
between 1 and 6.
(see fig. D).
again.
to a position
PWS 125 F5
Publicité
