Parkside 314188 2001 Traduction Des Instructions D'origine page 29

Permissible accessories
Cutting disc
Roughing disc
Storage and handling of the
recommended accessory tools
■ Grinding tools must be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical dam-
age or environmental influences (e.g. damp).
Working procedures
NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
PWS 125 F5
125 3 M14
125 6 M14
Two-hole assembly
6500 80
Two-hole assembly
6500 80
Rough grinding
Never use cutting discs
for rough grinding!
■ Move the angle grinder with moderate
pressure back and forth over the workpiece.
■
For soft material, move the roughing disc
at a flat angle over the workpiece; for hard
material at a slightly steeper angle.
Abrasive cutting
Never use roughing discs
for cutting!
■ Use only tested fibre-reinforced cutting
or grinding discs that are approved for a
peripheral speed of not less than 80 m/s.
Yes
spanner
Yes
spanner
GB │ IE │
25 ■