Publicité
Les langues disponibles
Les langues disponibles
Installing the product
Q
1. Rotate the solar housing
2. Move the ON / OFF switch
the product on.
3. Insert the solar housing
turning it clockwise.
For model A/C, please make sure the solar housing
correct position, the groove
in lamp shade (see fig.).
4. Take out the ground spike
and insert it into the housing
5. Your product is ready for use.
Setting up the product
Q
I nsert the assembled product far enough into the ground
(lawn, flower bed) for it to be stable.
M ake sure you keep proper footing and balance at all times.
Do not use any force when assembling or setting-up the prod-
uct, e.g. hammer blows. This will damage the product. In order
to achieve the best result, set the product up in a place where
the solar cell
D o not set the product up under bushes, trees, porches, etc.,
as this will reduce the amount of sunlight it receives.
P osition the product in such a way that the solar cell
covered or in shadow.
M ake sure that the solar cell
source of light such as yard or street lighting as otherwise the
light will not come on in twilight.
12 GB/IE/NI
anticlockwise out of the housing
2
8
into the housing
2
6
10
9
will get direct sunlight for as long as possible.
1
into the ON position to switch
9
must engage in the recess
from bottom of the housing
with the tip facing downwards.
is not influenced by any other
1
.
9
and tighten by
is in
2
3
9
is not
1
Publicité
