Télécharger Imprimer la page

Parkside PRM 1200 B2 Traduction Des Instructions D'origine page 27

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Operation
Hanging On / Removing
E
the Grass Box
1. To hang on the grass box (4), lift the
collision guard (7) and hang on the
grass box. Fold the collision guard
(7) onto the grass box (4). It holds the
grass box in the correct position.
2. To remove the grass box (4), lift the col-
lision guard (7) and detach the grass
box. Fold the collision guard (7) back
onto the mower housing (6).
The level gauge (
D
side of the grass box (4).
Flap (
D
grass box (4) empty
Flap (
D
grass box (4) full
Adjusting the Cut Height
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The electric lawnmower can be adjusted to
the following cutting heights with three po-
sition changes of the front and rear axles:
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
1. Place the lawnmower on its side.
F
2. Grasp the wheel axle on both
sides.
3. Pull evenly on the axle and let it
snap into the desired position.
20) is located on the
20) open:
20) closed:
The correct height is around 20 – 40 mm
for a decorative lawn and around
40 – 60 mm for a used lawn.
A higher cut height should be se-
lected for the fi rst cut of the season.
Observe the noise protection and
local regulations.
Switching On and Off
1. Connect the power plug of the exten-
sion cord to the power plug (
the curved handle (
2. To relieve the strain, form a loop with
the end of the extension cable and
hang this into the strain relief (11). See
the diagram
3. Connect the equipment to the power
supply.
4. Before switching on, ensure that the
equipment is not in contact with any
objects.
5. To switch on, press the release button
(10) on the handgrip. Hold down the
release button and press the start lever
(12). You can now let go of the release
button (10).
6. To switch off, release the start lever (12).
After switching off the equipment,
the blade continues to turn for sev-
eral seconds. Do not touch the mov-
ing blade. There is a risk of injury.
GB
9) on
A
1).
A
.
IE
27

Publicité

loading

Ce manuel est également adapté pour:

3308351907