Parkside PRM 1200 B2 Traduction Des Instructions D'origine page 26

GB IE
Electrical Safety:
• Ensure that the mains voltage
matches the specifi cations on
the rating plate.
• Only connect the device to a
socket with a residual current
device (RCD) with a rated re-
sidual current of no more than
30 mA.
• Avoid bodily contact with
earthed parts (e.g. metal fenc-
es, metal posts).
• To fi x on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Mounting the
bow-type handle
1. Insert the lower bar (3) into the
B
slot on the lawnmower housing
(6). Compare with the fi gure
2. Fix the bar (3) using the en-
closed screws (13).
26
3. Fix the curved handle (1) using
C
the enclosed screws (14) and the
wing nuts (2) on the lower bar
(3). There are two possible posi-
tions.
4. Clip the cable holder (
the bar (3) and to the curved
handle (1) and thus fi x the cable.
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment.
Ensure that the power cable is not
caught.
Assembling the
D
grass box
Wear protective gloves when
mounting the grass collection
box in order to avoid injury.
1. Connect the two pieces of the gras box
(4).
2. Connect the handle (15) in one of the
two pieces of the gras box (16). The
arrow markings on the handle (15) and
at the top of the grass grass (16) show
the alignment of the handle (15).
Do not work with the lawn mower
without impact protection. There is
a risk of injury.
We recommend always using the
grass box when working with the
lawn mower, otherwise the mow-
ing result may be signifi cantly im-
. paired.
A
8) into
A