Coway BIDETMEGA 400 Mode D'emploi page 37

Clean the product body
N OTE
 D o not use a thinner, benzene, detergents with abrasives, or rough scrubbers on the product.
 D o not use alkaline or acid detergent, it may cause discoloration or corrosion.
 M ake sure to follow the above instructions as, unlike other surfaces, the sea is highly susceptible to
scratches and rough scrubbers can scratch or peel the surface.
 D o not apply excessive force when cleaning the nozzle as it may break.
 O ur company is not responsible for defect caused by the customer disassembling and repairing the
product on his/her own. Please contact the service center when a product malfunction or defect occurs.
U se a soft cloth or sponge with a neutral detergent
to clean the bidet.
Failure to do so may result in product deformation or damage.
D isconnect the power plug from the electrical outlet when
removing and cleaning the nozzle/drying duct.
T he nozzle/drying duct can be washed with water, but it
must be completely dried before reassembling.
T he product body and the touch sensor controller should
never be cleaned with water.
C AUTION
How to separate the nozzle duct
-  S eparate the nozzle duct in the vertical direction as shown
in the figure.
-  W hen separating the duct, make sure not to drop it in the toilet.
C AUTION
How to separate the dry duct
-  A s shown on the figure, separate the drying duct in the
arrow direction.
37