Coway BIDETMEGA 400 Mode D'emploi page 12

02 HOW TO USE
Important! Important!
Connect product to power.
Plug the power cord and press the Power button on the control panel to turn on the bidet.
The power supply must be connected for the bidet toilet to operate properly.
T his product is for 120 V~ 60 Hz.
Connect the power plug to a grounded electrical outlet for 120 V~ 60 Hz(minimum 20 amps).
Open the water supply valve.
A water source must be supplied to the product for it to function properly.
After installing the product, remove the protection films on the main body and remote controller before use.
Check the remote controller status before using the product.
If the connection setting for remote controller communication (pairing) is not done or the main body's powered
off, the remote controller does not operate. If the bidet does not operate even if you press the remote controller
buttons, turn on the power of the main body and set the connection (pairing) of the remote controller. If the
battery needs to be replaced, each time you press a button, the LED blinks three times. When the battery is
discharged, the power is turned off.
✽  B atteries are not covered by the warranty. It is a consumable, and you need to replace it when it is necessary.
ECO GREEN system
-  T he 'hybrid instantaneous warm water' system sets adequate temperatures quickly during use (when seated).
The power saving system switches the bidet toilet to the standby mode when not in use to save the electric
power and lower the electric rates.
-  W hen the ECO GREEN system is disabled : This system maintains the same temperature in the warm water tank
just like the existing hot water storage type. The power saving function is off.
(The system can be disabled in the special mode.)
✽ When you purchase the product, the ECO GREEN system is enabled by default.
After installation
Check for leakage on the water supply valve and connection hose.
There must be a rubber washer between the T-shaped connector and the main water supply valve.
After taking a shower or cleaning the bathroom with water, make sure to wipe off moisture on the remote
controller with a soft cloth.
Prolonged periods of non-usage
If the product has not been used for a long time, clean the mesh filter, the nozzles, toilet seat, and other parts
according to the specified methods.
N OTE
Remove the protective film on the remote control before use.
12