Coway BIDETMEGA 400 Mode D'emploi page 15

How to set the remote controller connection (pairing)
How to pair the main body with the remote controller
Pairing involves connecting the remote controller to the controller receiver of the main body. You can perform the
pairing of the main body and remote controller in the following order and use your remote controller afterward.
1
Plug in the power cord, press the 'Rear' button
and 'Nozzle Clean' button on the right side of the
product at the same time and hold them for more
than 2 seconds. A buzzer sound and the LED will
start blinking. You will enter the communication
connection (pairing) setting mode.
2
Within 15 seconds after entering the
communication connection (pairing) setting
mode, press and hold the 'FRONT' button on the
remote controller for more than 5 seconds to
proceed with the pairing of the remote controller
and the main body's controller.
3
After pairing is completed, the remote controller's
LED (seat temperature, water/dry temperature)
blinks three times in orange, indicating that the
pairing is finished.
(However, the pairing operation is still possible
even after the recommended 15 second period.)
*  T he communication connection (pairing) setting mode is 
automatically turned off with a buzzer 15 seconds after entering the
mode regardless of whether pairing is finished.
(Complete pairing within 15 seconds after entering the paring
mode or retry to set up a connection.)
*  I n a case of failing of pairing, the remote controller's LED
(seat temperature, water/dry temperature) blinks once in red.
In this case, retry pairing again and if the problem persists,
contact the customer service.
15