Health O Meter 500KLHB Mode D'emploi page 8

Assembly Video
ASSEMBLY INSTRUCTIONS (CONTINUED)
3. Align column A and column B.
Notches are located at the bottom
of column A and the top of
column B. Snap the locking tab
into place. Ensure that the locking
tab is locked securely into place.
Note: When aligning and
locking the columns, use
caution not to pinch the load
cell connector cable.
4. Place the scale platform face up
on the foor. Read the "Attention"
label then remove it to allow the
column to be placed into the
cover.
5. Obtain the scale column and
locate the load cell cable. Align
the column above the platform
and wheel cover with the display
head facing the scale platform.
Carefully pull the load cell
connector cable from the bottom
of the column and plug into the
RJ jack on platform. Once
plugged in completely, lower the
column into the cover until it fits
tightly into the platform base. The
4 column fastening screws should
align into the four holes
underneath the wheel cover.
Alternate Method of Plugging in the
Load Cell Cable:
If having difficulty plugging the cable into
the port, complete step 8 then you may
also access the load cell cable via the
door on the rear of the cover. Use a
Phillips screwdriver to remove the door at
the back of the platform base then plug in
the cable and replace the door.
Column B
(top)
Locked position
Column
fastening
screws
Plug cable
into RJ Jack
Alternate method to plug cable into port:
7
Back to Home Page
Column A
Locking tab
Notches
Insert column into
wheel base cover
(bottom)