Health O Meter 500KLHB Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS (CONTINUED)
8. On the underside of the platform,
feed the wire for the power
adapter port through the base and
plug into the port. Note: Ensure
the wire is tucked into the slot in
the base as shown.
THIS STEP IS NECESSARY TO
POWER THE SCALE VIA AC
ADAPTER
9. Height Rod Assembly:
Locate the upper height rod D and
lower height rod E. Align upper
height rod D with lower height rod
E. Snap the locking tab into place.
Ensure locking tab is securely
locked.
10. Position the bottom of the fully
assembled height rod into the
height rod opening G at the top of
column A. Press locking tab F
inward to insert the height rod into
the height rod opening G. The
scale is now assembled and
ready to use.
Notch
Height rod E
Locking tab F
Locking tab F
9
Back to Home Page
Upper Height Rod D
Locking Tab
Lower Height Rod E
Height rod
opening G
Column A