Swivel Wheels; Accessories - Chicco 4 FOR ME Mode D'emploi

26. To remove the joinable handle, press the two central
levers inside, at the same time (diag. 26 A), and remove the
handle pulling it in an upward direction (diag. 26 B).
WARNING: Before using the stroller with the "joined handle",
always check that the handle has been fi tted correctly.
WARNING: To close the stroller, it is always necessary to
remove the joinable handle.
WARNING: Never use the joinable handle to lift the stroller
with the child sitting in it.
SAFETY BRAKE
The safety brake locks both of the rear wheels of the stroller
at the same time.
To ensure maximum functionality during use, the stroller has
a STOP & GO braking system marked by specifi c coloured
labels located on the rear braking levers.
27. To operate the brakes of the stroller, push the right lever
in a downward direction (diag. 27). The red STOP label will
appear automatically and the left lever will move upwards.
28. To release the brake, press the left lever in a downward
direction (diag. 28). The green GO label will appear
automatically and the right lever will move upwards.
WARNING: Always apply the brakes whenever the stroller is
stationary. Never leave the stroller on a sloped surface, with
a child on board, even with the brakes applied.

SWIVEL WHEELS

The stroller has front swivel or fi xed wheels. It is recommended
to use the wheels in the fi xed mode when manoeuvring
the stroller on particularly uneven surfaces. The use of the
wheels in the swivel mode is recommended to increase the
manoeuvrability of the stroller on a normal road surface.
29. To use the front wheels in the swivel mode, push the front
lever in a downward direction with your foot, as shown in
diagram 29. To use the front wheels in the fi xed mode, raise
the lever with the foot: the wheel will lock in the straight
position regardless of its previous position.
WARNING: Both wheels must always be locked or unlocked
at the same time.
CLOSING THE STROLLER
WARNING: When closing the stroller, ensure that your child,
or other children, are kept at a safe distance. Ensure that
during these operations the moveable parts of the stroller do
not come into contact with your child.
The stroller can be closed with the seat both in the FORWARD
FACING and in the REAR FACING position. The instructions
to be followed are the same for both positions. However, to
make the frame ultra compact when the stroller is closed, it is
recommended to close the stroller with the seat fi tted in the
FORWARD FACING position.
30. Raise the calliper shaped mechanisms on the sides of the
hood and fold the hood (diag. 30).
31. Pull both of the trigger open mechanisms, located on the
handles, in an upward direction; while keeping them pulled,
unlock the rear locking mechanism, pushing it in an upward
direction with the tip of the foot (diag. 31).
32. Hold the close handle and pull in an upward direction,
until the stroller is completely closed and locked (diag. 32).
33. To make the stroller more compact when closed, recline
the backrest to the horizontal position (diag. 33).
34. Fold the handles in a forward direction (diag. 34).
When the stroller is closed and locked, it stands upright on
its own.
WARNING. To close the stroller, it is always necessary to
remove the joinable handle (if present).
HOW TO REMOVE THE FABRIC COVER
Hold the stroller in a semi-closed position with the safety
harness open:
35. Unfasten the press studs in the points shown in diagram 35.
36. Raise the leg rest and remove the fabric cover, taking care
to slide the safety harness through the cover (diag. 36 A);
remove the cover from the backrest, pulling it in an upward
direction (diag. 36 B).
HOW TO USE THE CHILD CAR SEAT AND CARRYCOT
The CHICCO strollers featuring the CLIK CLAK system on
the armrests allow you to fi t the carrycot and/or child car
seat to the frame of the stroller without using any additional
devices.
To fi t or remove the carrycot or child car seat, please refer to
the specifi c instructions supplied
37. Before fi tting the child car seat or carrycot, unfasten the
upper part of the armrest covers or remove them completely
(diag. 37 A and B).
WARNING: Only the CHICCO child car seats and carrycots
featuring the CLIK CLAK devices can be fi tted to the stroller.
Before using the stroller with the carrycot or child car seat
fi tted to it, always check that the locking system is locked
into the correct position.
ONLY USE ACCESSORIES FITTED WITH THE SPECIFIC CLIK
CLAK SYSTEM.
38. WARNING: The incorrect locking of these accessories to
the stroller frame may jam the locking system and prevent
their removal. In this case, unlock the locking devices
manually with a screwdriver, by turning the levers located
under the armrests. The levers can be accessed through the
appropriate opening (diag. 38).

ACCESSORIES:

WARNING: The accessories described below may not be
available for some versions of this product. Please read
carefully the instructions on the accessories available for the
model purchased.
COMFORT KIT
The Comfort Kit includes 2 shoulder strap covers and an
abdominal band, both in mesh. The abdominal band is
particularly recommended when the seat is used in the rear
facing position, when the child is small.
39. Insert the shoulder straps into the strap covers, as shown
in diagram 39.
40. Insert the crotch strap into the appropriate hole (diag. 40
A) and the buckles of the waist belt into the holes located on
the sides (diag. 40 B).
WARNING: Insert the abdominal band after sitting the child
in the stroller.
WARNING: If necessary, adjust the width of the waist belt
operating the buckles.
WARNING: To ensure your child's safety, it is necessary to
always use the safety harness.
WINTER HOOD/SUMMER CANOPY
41. The seat has two slots, located on the sides, which allow
you to fi t the hood. To fi t the hood, insert the locking systems
into the slots, as shown in the diagram 41. As it is fi tted to
the seat, the hood does not need to be turned every time the
24