Sony HT-CT100 Mode D'emploi page 37

Control for HDMI
The Control for HDMI function does not work.
• Check the HDMI connection (page 9).
• Make sure "CTRL: HDMI" is set to "ON" in
AMP menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on the
connected component. Refer to the
operating instructions supplied with the
connected component.
• If you change the HDMI connection, or
connect/disconnect the AC power cord
(main lead), or if there is a power failure,
repeat the procedures of "Preparing for the
"BRAVIA" Sync" (page 21).
• The system may not work correctly if you
select a component that is not compatible
with the Control for HDMI function on the
TV side.
• Make sure "DVD CTRL", "SAT CTRL" or
"DMPORT. CTRL" is set to "ON" in AMP
menu.
No sound is output from the system and the
TV's speaker.
• Check the volume of the system and the TV.
• Select the input of the system correctly.
The sound is output from both the system and
the TV.
• If the Control for HDMI function is set to
off, or the selected component is not
compatible with the Control for HDMI
function, turn off the sound of the system or
the TV.
The System Power Off function does not work.
• Change the setting of the TV to turn
connected components off automatically
when you turn off the TV. For details, refer
to the operating instructions of the TV.
An image does not appear on the TV.
• Check whether HDMI IN and HDMI OUT
are connected correctly.
A message stating that the output method has
changed from the system speaker to the TV
speaker, appears on the TV screen.
• The Control for HDMI function for the
selected component is set to off. For details,
refer to "Setting the Control for HDMI
function to off for a component without
HDMI jacks" (page 23).
Other
The remote does not function.
• Check that the active subwoofer and the
satellite speaker are connected correctly and
securely.
• Point the remote at the remote sensor
the satellite speaker.
• Remove any obstacles in the path between
the remote and the satellite speaker.
• Replace both batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on the
remote.
The volume turns down when the output
method changes from the TV speaker to the
system speaker.
• The Volume Limit function is working. For
details, refer to "Using the Volume Limit
function" (page 25).
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the system for the operation.
1
Press ?/1 to turn on the power.
2
Press INPUT SELECTOR, VOLUME –
and ?/1 at the same time.
"COLD RESET" appears and the system is
reset. AMP menu, sound field etc., return to
the default settings.
on
37
US