SilverCrest SESR 6 A1 Mode D'emploi page 17

3 . Place the head of the attachment
directly onto the sneaker surface to be
8 ] [
cleaned .
4 . Switch on the product . The attachment
/ starts rotating .
7 ] [ 8 ] [
5 . Gently glide the head of the
attachment /
[ 6 ] [ 7 ]
surface in a slow, circular motion .
˜ Troubleshooting
Problem
The product does not work .
The attachment /
6 ] [
does not rotate .
˜ Cleaning and maintenance
˜ Cleaning
(Fig . C, F)
m NOTICE! Risk of property damage!
/
6 ] [ [ 7 ]
/ over the sneaker
8 ] [
Possible cause
The batteries
The batteries
incorrectly .
Too much pressure is applied on
/
[ 7 ] [ 8 ]
the attachment
Debris or hair is tangled around
the attachment
6 . Use a slightly damp, clean cloth to remove
/
residues of dirt or sneaker cleaning
detergent from the sneaker surface .
7 . Repeat the steps above until the cleaning
/
6 ] [
result is satisfactory .
8 . Cleaning completed: Switch off the product .
The attachment
are discharged . Replace the batteries
[ 5 ]
are inserted
[ 5 ]
/ / .
6 ] [ 7 ] [ [ 8 ]
/ / .
[ 6 ] [ 7 ] 8 ] [
Never immerse the main unit
or any other liquid . Never hold the product
under running water .
Do not allow water or other liquids to get
inside the product .
Do not use abrasive, aggressive cleaning
materials or hard brushes for cleaning .
/ / stops rotating .
[ 6 ] 7 ] [ 8 ] [
Solution
Insert the batteries
[ 5 ]
correctly .
Reduce the pressure on the
attachment / /
6 ] [ [ 7 ] [ 8 ]
Remove debris or hair from the
attachment / /
6 ] [ 7 ] [ [ 8 ]
in water
[ 1 ]
GB/IE/NI
.
5 ] [
.
.
15