ProMinent DULCOLEVEL Mode D'emploi page 13

Initial Startup
Connect Sensor to Pump (Wizard)
Use the wizard in the DULCONNEX Blue App to connect
the sensor to the pump.
Prerequisites:

DULCONNEX Blue App is installed on your mobile de-
vice. You cannot set up or operate the sensor without
the app.

Bluetooth ® is enabled on your mobile device and
pump.

The sensor and the pump are connected to power.
Procedure:
1. Open DULCONNEX Blue on your mobile device.
2. Switch to the "Devices" view.
+
3. Tap on .
All Bluetooth devices that are nearby are displayed.
4. Tap on .
The wizard will start and guide you through the con-
nection process.
The sensor is connected to the pump and the pump is
displayed in the "Devices" view in the "Connected" tab.
Note: During set-up you will need the last 4 digits of your
sensor's and pump's serial numbers.
Alternative: Connect Sensor Only
If you do not have a pump with Bluetooth
use the sensor with a PLC as described in application
option 3, follow the steps below.
Prerequisites:

DULCONNEX Blue App is installed on your mobile
device. You cannot set up or operate the sensor
without the app.

®
Bluetooth is enabled on your mobile device.

The sensor is connected to power.
® and want to
13 EN