Publicité
Les langues disponibles
Les langues disponibles
Initial start-up
In the following cases, the LMI03 starts up with the 'No Setup' alarm screen:
n
Turning on a new unit
n
After installing a new control PCB in a unit
n
After resetting to factory settings
n
After replacing the CMOS battery
Performing initial start-up
Requirements:
n
LMI03 is fully installed.
1.
Switch on the unit.
ð The 'No Setup' screen appears.
2.
Press to operate the device.
3.
Enter the access code with
ð The 'Options' screen (12) appears.
4.
Carry out the device setup (see the main operating instructions
instructions' on page 3 ).
5.
Make the device settings (see the main operating instructions
instructions' on page 3 ).
MAN049701 Ver. 02-03.2024
and confirm with
24
.
Ä
'Available
Ä
'Available
Publicité
