Publicité
Les langues disponibles
Les langues disponibles
Attach the Rear Wheels
1
4
3
x2
11
2
6
5
Labeled "R"
1. Insert the rear axle to pass through the holes in the rear axle beam.
2. Slide the rear gear box on the rear axle (HINT: "R" labeled gear box should
be fit to the "R" marked side of the vehicle body, "L" labeled gear box should
be fit to the "L" marked side of the vehicle body). Insert the connector on the
gear box into the hole in the vehicle body and reach the battery compartment.
3-4. Fit the wheel driver to the wheel. Insert and tighten six Ø4x16 screws to
secure the wheel driver to the wheel.
5. Slide a Ø12 washer onto rear axle.
6. Tighten a Ø10 lock nut to the end of the rear axle with a spanner (included).
7-10. Repeat steps 2-6 to assemble the other rear driving wheel. HINT: An
extra spanner has been provided to hold the lock nut on the other side of the
rear axle while tightening the lock nut on the other side.
11. Snap the hubcaps to the wheels.
14
Rear Bottom View
7
8
9 10
Marked "R"
Rear Bottom View
RC Type ( With RC Function ) - Attach the Steering Column
4
11
● Turn the vehicle body on its side.
1. Insert the straight end of the steering column into the hole in the R/C gear
box.
2. Push the steering column so that its gear matches into the R/C gear box ,
and insert its bent end through hole in the the steering linkage, finally ensure
its straight end out through the hole in the dashboard (2a).
3. Fit a Ø12 washer onto the bent end of the steering column.
4. Fit the snap ring into the groove in the bent end of the steering column.
3
1
2
Hole in the steering linkage
Front Bottom View
2a
Left Side View
15
Publicité
