Costway TQ10228 Mode D'emploi page 7

(All Wheel Drive) - Attach the Front Wheels
Front Bottom View
1
9 8 7
Remove all the parts from the front axle.
Turn the vehicle body upside down.
1. Slide a Ø12 washer onto the both front axle rods.
2. Fit the front axle rods into the holes at both ends of the front axle holder.
3-4. Slide a Ø12 washer onto the front axle rod. Tighten a Ø10 lock nut to the
end of the front axle rod with a spanner. Repeat for the other side.
5. Plug the connector on the front gear box into the connector from the vehicle
body.
6. Slide a wheel onto the front axle.
7. Slide a Ø12 washer onto the front axle.
8. Tighten a lock nut to the end of the front axle with a spanner. DO NOT over
tighten.
9. "Snap" the hubcap to the wheel.
Repeat the above procedure 5-9 to assemble the other Front Wheel.
12
2
Ø12 washer
1
Front axle holder
6
Front Bottom View
5
Attach the Rear Axle Beam & Rear Support
Front axle rod
3
4
Slot for nut
1. Remove the M6x30 machine screw and
Ø6 nut on each shock pipe.
2-3. Lift up the rear axle beam, and rotate
down the both pipes. Insert the both pipes
into the shock holder on the vehicle body
at the same time.
4-5. Place the Ø6 lock nut you removed in
step one into the slot on the shock holder.
Tighten the M6x30 machine screw on the
opposite side. Repeat for the other shock
pipe.
6. Fit the rear support to the rear of the
vehicle body. Use a screwdriver to tighten
six Ø4x12 screws to secure it.
2
3
Shock holder
5
4
6
Shock pipe
1
Rear Bottom View
Rear Bottom View
13