Husqvarna T540i XP Manuel D'utilisation page 26

6. Make sure that the bar tip sprocket turns freely and
that the lubricating hole in the bar tip sprocket is not
blocked. Clean and lubricate if it is necessary.
7. Turn the guide bar daily to extend its life cycle.
To adjust the chain oil flow
WARNING:
make adjustments to the oil pump.
User interface
LED screen Possible faults
The warning in- Chain brake is
dicator flashes. engaged.
Temperature
deviation.
Overload. The
saw chain can
not move.
The power trig-
ger and the
start/stop but-
ton are pushed
at the same
time.
Green activate Low battery
LED flashing. voltage.
The warning in- Service.
dicator is on.
26
Stop the motor before you
Troubleshooting
Possible solution
Disengage the chain brake.
Let the product to cool down.
Release the saw chain.
Release the power trigger to activate the product.
Charge the battery.
Speak to your servicing dealer.
• Turn the adjustment screw for the oil pump. Use a
screwdriver or the combination wrench.
a) Turn the adjustment screw counterclockwise to
increase the oil flow.
b) Turn the adjustment screw clockwise to decrease
the oil flow.
1036 - 012 - 09.05.2024