Husqvarna T540i XP Manuel D'utilisation page 15

4. Push on the lower part of the battery until you hear a
click.
5. Push and hold the start/stop button until a green
LED light comes on.
WARNING:
tree, engage the chain brake before you let
the product hang from a strop.
To use the SavE function
The SavE function decreases the chain speed and the
power of the product.
1. Push the SavE button quickly. The green LED
comes on.
2. Push the SavE button again to disconnect the
function. The green LED goes off.
To engage and disengage the heat in
the handles (T540i XPG)
The product has heated handles.
• Push and hold the SavE button for 1 second to
engage the heat in the handles. The indicator for
heat in the handles comes on.
1036 - 012 - 09.05.2024
If you start the product in a
• Push the SavE button quickly to disengage the heat
in the handles. The indicator for heat in the handles
goes off.
Oil level indicator
The oil level indicator shows when it is time to fill chain
oil.
1. When the oil level indicator comes on, fill with chain
To use the correct chain oil on page 13 .
oil. Refer to
2. Start the product and wait 1-2 minutes. The oil level
indicator goes off.
To stop the product
1. Push and hold the start/stop button until the green
LED light comes off.
2. Push the battery release buttons and remove the
battery from the battery holder to prevent accidental
start.
General information about working
technique
Below we give you some general information about how
to use this product.
WARNING:
working technique in this operator's manual
is not considered correct training to operate
this tree-service product. This product must
be used by tree-service operators with
special training only! Use without the correct
The information related to
15