Inglesina LODGE Manuel D'instructions page 15

HINTS FOR CLEANING THE TEXTILE LINING
• Periodically revive the fabric parts using a soft clothes brush.
• The product is surface wash only. Clean with a damp cloth and
mild soap; do not use solvents, ammonia or bleach. Do not use
abrasive cleaners or scrubbing pads.
• Follow the lining washing instructions on the labels.
Do not bleach
Do not tumble dry
LIST OF COMPONENTS
fig. 1
A Travel cot frame
B Mattress base
C Upper level
D Tubes for the upper level
E Mosquito net
HOW TO SET UP THE TRAVEL COT
fig. 2 Open the bag and take all the parts out.
fig. 3 Unfasten the 3 velcro straps that are around the
mattress base.
Unfold the travel cot (A).
fig. 4
Grasp the travel cot at the shortsides and pull upwards
fig. 5
until they are engaged. Repeat the same process for the longest
sides.
fig. 6 Make sure that all 4 sides of the travel cot are correctly
engaged then push down the bottom pressing the centre.
WARNING! Don't reverse the above steps. It won't be possible
to engage the 4 rails if the bottom is pressed down.
fig. 7 Install the mattress base on the bottom (B) and fasten
it by passing the 4 straps (F) in the holes and closing the velcro.
HOW TO FOLD THE TRAVEL COT
Remove the mattress base (B) from the bottom.
fig. 8
• IMPORTANT
L I
ATTENTIVEMENT
CONSERVER
C O N S U L T A T I O N
FUTURE.
• NE PAS TENIR
DES MISES EN GARDE ET DES
INSTRUCTIONS
AVERTISSEMENTS
-
R E
ET
POUR
COMPTE
Dry flat in shade
Do not iron
Do not dry clean
Do not spin-dry
• Dry the mattress completely before using or storing it.
Grasp the lever (G) in the middle of the bottom and rotate it
clockwise until you reach the unlocking position.
fig. 9 With the lever still rotated (G) pull up the bottom of
the travel cot for about 20 cm
fig. 10 Push the button (J) in the middle of each side and press
down so that all 4 rails fold.
fig. 11 Pull up the centre and gather the unit together.
fig. 12 Wrap the mattress base (B) around the travel cot with
the soft part inside and close the velcro straps.
HOW TO SET UP THE UPPER LEVEL
First of all correctly open the travel cot. Then attach the
fig. 13
support for the upper level (C) to the rails using the plastic hooks
(H).
fig. 14 Snap the support to all 4 edges (K).
fig. 15 Insert the 4 tubes (D) in the housings (L) at the bottom
of the support and insert them in one another to fully open the
upper level.
fig. 16 Place the mattress base (B) on the bottom of the upper
level.
MOSQUITO NET
Put the mosquito net (E) over the travel cot and attach
fig. 17
it by passing the hooks (M) in the buttonholes (N) on the angles.
INSTRUCTIONS FOURNIES PEUT
S'AVÉRER TRÈS
POUR VOTRE ENFANT.
• VOUS ÊTES RESPONSABLE DE
LA SÉCURITÉ DE VOTRE ENFANT.
• AVERTISSEMENT! NE JAMAIS
LAISSER VOTRE
SANS SURVEILLANCE.
LE MAXIMUM
LORSQU'ON UTILISE LE PRODUIT.
DANGEREUX
ENFANT
FAIRE
D'ATTENTION
15