Publicité
Les langues disponibles
Les langues disponibles
Commissioning / After initial use / Maintenance / Cleaning and Care
Correctly holding the
equipment
This equipment weighs 2.1 kg.
Hold the equipment with both hands to ensure
safe operation (see Fig. D).
After initial use
Once the task has been finished the device must be
disconnect from the compressed air supply
Switch off the compressor.
Briefly activate the trigger
to release any residual compressed air.
Now pull back the safety on the connection
coupling of your compressed air hose.
Now remove the hose from the plug nipple
device down. Always put down the device so it
does not rest on the trigger. This could potenti-
ally result in inadvertent activation of the tool,
which in turn could result in hazards.
Maintenance
ATTENTION! All maintenance must be per-
formed by trained individuals. Follow the specified
maintenance instructions to ensure a long life and
proper operation of this quality product.
Disconnect equipment from the compressed air
source when performing maintenance and care.
Check the condition of wear and tear items
and accessories with each maintenance.
Note: Daily cleaning and regular lubrication
are an absolute necessity for smooth operation.
Only use special tool oil with a high viscosity
(thin fluid). Oil for compressed air tools or
SAE10-20 motor oil are suitable.
ATTENTION! Do not use other (especially
high viscosity) lubricants. Malfunctions or per-
manent damage may otherwise occur.
275671_par_Druckluft-Schlagschrauber PDSS_content_AT_CH.indd 55
.
2
of the equipment
4
9
Careful when putting the
The following lubricating options are
available:
a) via the lubricator
Fill the lubricator included
by first unscrewing the inlet screw from the lu-
bricator.
Now install the lubricator
air supply as described in chapter „Establishing
connections".
b) via oil-mist generator
If a complete maintenance unit with oil-mist
generator is installed on your compressor the
lubricator
does not necessarily need to be
11
mounted.
To use the oil-mist generator plug the plug
nipple
directly into the equipment and con-
9
nect with your air hose.
.
c) by hand
Alternatively you can also manually lubricate
your equipment (not recommended).
To do so, remove the screw plug on the oil filler
port
.
5
Apply 3–5 drops of oil to the compressed air
connection and the oil filling port
using the compressed air tool.
If the air tool has not been used for several
days 5–10 drops of oil must be added to the
air connection
2
Note: Regular lubrication is imperative to ensure
the longest possible life for your compressed air de-
vice. We recommend continuous lubrication via the
included lubricator
11
Always store your air tools / equipment in dry
locations.
No maintenance is required beyond the above
lubrication and cleaning.
Cleaning and Care
Only clean the tool with a dry cloth.
Never clean with fluids such as petrol, solvents
or water.
Do not allow liquids to enter the equipment.
11
with a bit of oil
11
in the compressed
11
before
5
and the oil filler port
.
5
.
GB
09.05.16 14:13
55
Publicité
