Wine Cell'R WC46DZSV1 Manuel D'utilisation Et D'entretien page 14

1. Take out handle from cabinet, then take out 2pcs screws from accessory
bag
(Note: the screws of some models have been put on the door. If the door
is made of all black glass, two white insulating columns shall be sleeved on
the screw holes to prevent the metal screws from bursting the glass.)
2. Pull open door seal from the side of door, then insert screws into the 2
handle holes on side of door, then put the screws alignment the hole of
handle, tighten the screws by Phillips screwdriver，then compress the door
seal
NOTE
If the screws holes of the handle don't match perfectly with the holes of
the door, please use the electric drill to drill the holes of the door a bit big
(in surface side), in order to install the handle perfectly.
VENTILATION KICK PLATE INSTALLATION METHOD
Take out Ventilation frame from cabinet, then take out 4 pcs 4 * 12 screws from accessory bag.
Open the door, align the ventilation frame to the four screw holes in the bottom of the cabinet and tighten the screw
with Phillips screwdriver.
HANDLE INSTALLATION METHOD