Publicité
Les langues disponibles
Les langues disponibles
WARNING: To avoid accidents during the process of changing the door, we recommend that you get assistance. The
glass door is heavy and may cause injury if dropped.
Depending on to the model and the type of handle your wine cabinet is equipped with, you may have to rotate the door
through 180 degrees.
REMARK: WC2743SSBC with French doors, the doors do not reverse.
Tools & Parts required
1.Decorative nail
2. Small tool
3. Drop-proof device
4. M5 six angle
5. M5 six angle screwdriver
6. Door spindle core
7. Upper door hinge
8. Lower door hinge
5. Discharge the upper and lower door hinge
(7)(8) by M5 inner six angle screwdriver
(Tool 5), then to assemble the door hinge on
the opposite side. (Drawing 3 and 4).
6. Rotate the door 180 degrees, then install the
door on the right side of the cabinet.
(Drawing 5).
7. Finally, install the decorative nail and drop-
proof device at the opposite side (Drawing
6).
8. To put the cabinet on open operation place,
the door opened to the maximum angle.
9. Use small tool (2) to take off the decorative
nail (1) on opposite side (Drawing 1).
10. Use the inner six angle screwdriver (Tool 5)
to disassemble the screws (4) of drop-proof
device (3), then remove the drop-proof
device. (Drawing 1).
11. Hold the door, use six angle screwdriver
(Tool 5) to screw out the door shaft core (6)
from the two ends of the top of the door.
Take out the door and set aside. (Drawing 2).
12. Discharge the upper and lower door hinge
(7)(8) by M5 inner six angle screwdriver
(Tool 5), then to assemble the door hinge on
the opposite side. (Drawing 3 and 4).
13. Rotate the door 180 degrees, then install the
door on the right side of the cabinet.
(Drawing 5).
14. Finally, install the decorative nail and drop-proof device at the opposite side (Drawing 6).
REVERSIBILITY OF THE DOOR
1.
To put the cabinet on open operation place, the door opened to the
maximum angle.
2.
Use small tool (2) to take off the decorative nail (1) on opposite side
(Drawing 1).
3.
Use the inner six angle screwdriver (Tool 5) to disassemble the screws
(4) of drop-proof device (3), then remove the drop-proof device. (Drawing 1).
4.
Hold the door, use six angle screwdriver (Tool 5) to screw out the door
shaft core (6) from the two ends of the top of the door. Take out the door and
set aside. (Drawing 2).
WINECELLR.CA
13
Publicité
