Parkside PBSA 12 D4 Traduction Des Instructions D'origine page 138

GB IE
• Only use chargers from the Parkside X
12 V Team series to recharge the batte-
ry.
• If the operating time is considerably
shortened despite charging, this shows
that the rechargeable battery is deple-
ted and must be replaced. Only use an
original replacement battery from the
Parkside X 12 V Team series, which
can be purchased from the online shop
(see the "Spare parts" section).
• Always comply with the latest safety
information, as well as the regulations
and information relating to environmen-
tal protection.
• Defects resulting from improper hand-
ling are not covered by the guarantee.
Inserting/removing the
battery
1. To remove the battery (1) from the de-
vice, press both release buttons (2) on
the battery and pull the battery out.
2. To insert the battery (1), push the batte-
ry along the guide rail into the device.
You will hear it click into place.
Only insert the rechargeable
battery once the battery-ope-
rated tool is ready for use.
Checking the battery charge
level
The battery's (1) charge level is indicated
by the charge state indicator.
• The charge level of the battery is indi-
cated by illumination of the correspon-
ding LED lights while the device is in
operation. Press and hold the power
button to view.
20
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red => Battery needs
to be charged
Recharging the battery
If warm, allow the battery to cool
before charging.
Charge the battery (1) when only
the red LED on the level indicator is
illuminated.
The battery's (1) charge level is indi-
cated by the charge state indicator.
The charging time is around 1 hour
(PAPK 12 A2).
1. Remove the battery (1) from the appli-
ance if necessary.
2. Plug the battery charger (3) into a
mains outlet.
3. Insert the battery (1) in the charging
compartment of the battery charger (3).
4. Pull the battery (1) out of the battery
charger (3).
5. Unplug the battery charger (3) from the
mains.
Overview of the LED indicators on
the charger (3):
Green LED (5) lights up wit-
hout battery inserted: Char-
ger ready.
Green LED (5) lights up:
Battery such alleged
charged.
Red LED (4) lights up: Battery
charging.
Red LED flashes: Error