Parkside 281995 Traduction Des Instructions D'origine page 24

Fitting the splinter guard
The splinter guard can prevent the tearing up of
the surface when sawing wood. The splinter guard
can only be used with certain sawblade types
without the sliding shoe
angle of 0°.
♦ Press the splinter guard
from below (notch facing upwards).
Fitting the sliding shoe
When working on sensitive surfaces, you can fit
the sliding shoe on the baseplate
scratching the surface.
♦ Mount the sliding shoe
baseplate and press it up at the back until it
clicks into place on the baseplate
♦ To remove the sliding shoe
the rear of the baseplate
front.
Use
Setting the cutting angle
♦ Undo the clamping screws
hex key and pull the baseplate
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Retighten the clamping screws
key.
│ GB │ IE
■ 20
and only at a cutting
into the footplate
to prevent
onto the front of the
.
, unfasten it at
and slide it off the
with the supplied
to the rear.
forwards so that the
.
with the hex
NOTE
► When using a cutting angle of 15°/30°/
45°, the blade guard
guard must be detached beforehand.
Setting the stroke rate
The ON/OFF switch
trol. Press the ON/OFF switch
speed. Increasing the pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.
Adjusting the pendulum stroke
♦ You can use the pendulum stroke switch
to adjust the pendulum movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0").
Deactivate pendulum movement when working
on thin workpieces. You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (settings 1–3).
Switching on/off
Switching the appliance on:
♦ Push the safety lock-out
and keep it pressed.
♦ Press the ON/OFF switch
Once the saw is running, you can release
the safety lock-out
illuminates when the ON/OFF switch
depressed lightly or completely. This provides
illumination of the work area in poor lighting
conditions.
Switching the appliance off:
Release the ON/OFF switch
.
and the splinter
has a variable speed con-
lightly for a low
to the left or right
.
. The working light
is
.
PSTDA 20-Li A1