Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Aqua Clean function
This function makes it easy to remove grease and other food debris that may have stuck to the
sides of the oven. For easier cleaning, do not allow dirt to accumulate. Clean the oven frequently.
Attention
Do not pour water into a hot oven as this can damage the enamel of the oven. Always
run the cycle on a cold oven. The result could be affected and the varnish damaged if it
is run when the oven is too hot.
1.
First, remove all accessories and guide rails from the oven interior.
2.
With the oven cold, spread a cloth out on the bottom of the oven.
3.
Gently pour 200 ml of water onto the cloth on the bottom of the oven cavity.
For best results, add a teaspoon of mild washing up detergent to the glass of water
before pouring onto the cloth.
4.
Turn the function control dial to the
5.
Turn the temperature control dial to 90º C.
6.
After 24 minutes; turn the function control dial and the temperature control dial to
7.
Wait for about 20 minutes for the interior of the oven to cool.
▷ Any traces of dirt and excess water can now be removed from the oven with the damp
cloth.
Attention
Do not open the oven door until the Aqua Clean function is complete. The cooling cycle
is necessary for the function to work properly. Before touching the inside surface of the
oven, make sure that it has cooled properly.
The Aqua Clean function takes place at a low temperature. However, cooling times can
vary depending on the room temperature. If a deeper clean is required after using the
Aqua Clean function, use neutral detergents and non-abrasive sponges.
EN 10
position.
.
Publicité
