mundoclima MUCSR-H14 Manuel D'installation Et De L'utilisateur page 67

Maintenance after a long stop period
(eg. at the beginning of the season)
Check and remove everything that might be blocking inlet and
outlet vents of indoor units and outdoor units.
Clean air filters and casings of indoor units.
Refer to "Cleaning the air filter" for details on how to proceed
and make sure to install cleaned air filters back in the same
position.
Check and remove everything that might be blocking inlet and
outlet vents of indoor units and outdoor units.
Clean air filters and casings of indoor units.
Refer to "Cleaning the air filter" for details on how to proceed
and make sure to install cleaned air filters back in the same
position.
Turn on the power at least 12 hours before operating the unit in
order to ensure smoother operation. As soon as he power is
turned on, the remote controller displays appear.
Maintenance before a long stop period
(eg. at the end of the season)
Let the indoor units run in fan only operation for about half a day
in order to dry the interior of the units.
Clean air filters and casings of indoor units. Refer to " Cleaning
the air filter" for details on how to proceed and make sure to
install cleaned air filters back in the same position.
Cleaning the air filter
The air filter can prevent the dust or other particulate from
going inside. In case of blockage of the filter, the working
efficiency of the air conditioner may greatly decrease .
Therefore, the filter must be cleaned once two weeks during
long time usage.
If the air conditioner is installed in a dust place, clean the air
filter frequent.
If the accumulated dust is too heavy to be cleaned, please
replace the filter with a new one(replaceable air filter is an
optional fitting).
1
Open the air-in grill
Push the grill switches towards the middle simultaneously.
Then pull down the air-in grill.
The control box cables ,which are originally connected with
the main body electrical terminators must be pulled off before
doing as indicated above.
2 Take out the air-in grill (together with the air filter).
Pull the air-in grill down at 45 and lift it up to take out the
grill.
3 Dismantle the air filter.
4
Clean the air filter
Vacuum cleaner or pure water may be used to clean the air
filter.If the dust accumulation is too heavy , please use soft
brush and mild detergent to clean it and dry out in cool place.
The air-in side should face up when using vacuum cleaner.
The air-in side should face down when using water.
CAUTION
Do not dry out the air filter under direct sunshine or with
fire.
5
Re-install the air filter.
6
Install and close the air-in grill in the reverse order of step 1
and 2 and connect the control box cables to the
corresponding terminators of the main body.
67