Publicité
Les langues disponibles
Les langues disponibles
Every time the spa is reused after a power off, the temperature
needs to be reset, otherwise the spa can only be heated to 100℉
the spa cover needs to be covered during heating and the lock
button needs to be inserted.
Adding an inflatable air bladder and floor mat to the spa will provide
better heating and insulation effects.
In addition, other factors can also be
mistaken for not heating.
1. When setting the target temperature of 104 degrees Fahrenheit,
the following situations may occur. The heating program is
completed within ten hours, and when the water temperature
reaches 104, the heating tube automatically shuts down and enters
insulation mode.
In insulation mode, the heating button only lights up and the heating
tube does not work. When the water temperature drops below the
set temperature by 2 degrees Celsius (approximately 3.6 degrees
Fahrenheit), the heating mode will be automatically restarted.
Therefore, when you see the setting of 104, you may see a water
temperature of around 100.
2. When the target temperature is set to 100 (the default heating
target temperature is 100), the above situation will still occur, and the
final displayed temperature may be around 96.
The above two situations do not mean that the heating cannot reach
the target temperature, but rather enter the insulation state. That is
to say, if the water temperature continues to naturally cool down, the
heating will automatically restart until the target temperature is
reached. Due to the insulation effect of the pool cover, the cooling
rate is relatively slow, and it will stay for a long time at a certain
temperature.
34
1.When using BUBBLE in the pool, it
is normal for the temperature to drop
quickly because the heat dissipation
is faster when using BUBBLE.
2.After opening BUBBLE for 20
minutes, it will stop blowing for 10
minutes to protect the motor. If you
forcibly use BUBBLE, you can power
off and restart it before use.
The temperature sensor is located inside the water outlet of the spa.
During the static heating process, the overall flow of the water slows
down, so the water temperature near the water outlet will be slightly
higher.
On the contrary, the water temperature at the far end of the outlet
will be slightly lower.
When you enter the spa and the heating process, if you turn on the
bubble, which accelerates the water flow in the pool and dissipates
heat faster. In addition, the previously distant low-temperature water
flows back to the vicinity of the water inlet.
At this point, a significant decrease in water temperature is a normal
phenomenon.
Long time use will lead to slight
expansion of SPA, which is a
normal phenomenon and looks
like air leakage. We just need to
restart the connecting inflation
hose to inflate. It is a normal
phenomenon that bubbles will
emerge from the airway hole in
the pool during inflation.
After using the spa, you can use a bandage to quickly store the pool,
reducing its size and saving space.
If there is no water in the pool,
filtration and heating cannot be
turned on. If there is no water in
it, prolonged activation of
filtration can cause abnormal
noise and jamming of the
filtration pump. Water must
be filled before use.
35
Publicité
