Publicité
Les langues disponibles
Les langues disponibles
Temperature set too low.
The
heater
The water temperature
system
is still within
does not
35.6°F(2°C)below the
work.
set temperature.
Spa is not covered
Low ambient
temperature or
strong wind.
The air bubble function is
The spa
activated when heating
heats
the spa water.
slowly.
Water level too low. In
this case, the temperature
reads rises rapidly but the
water temperature does
not.
Dirty filter cartridge &
cover.
The bubble pump
protection is on.
Bubble
system
does not
work.
The bubble pump
overheats.
30
Set a higher temperature
68°F-104°F/20°C-40°C.
Once the set water temperature
reached, the heater will stop working
until the water temperature drops
35.6°F(2°C)below the set temperature.
In this case, just wait for a few minutes
and the heater will start working
automatically.
Attach and secure the SPA Cover(D).
The ambient temperature is lower than
50°F(10°C).
Outdoor wind speed is above 3.5-5.4
m/s (8-12 mph). This is normal not a
product quality issue.
Turn off the bubble function.
Fill the water til it stays between the MIN
and MAX waterline.
Clean the filter cover and replace the
filter cartridge
The air bubble system is designed with
a 20-minute auto shutoff feature. Wait
for 10 minutes after the 20-minute
bubbling if you would like to restart the
bubbling again.
Unplug or turn off the spa, wait until the
motor has cooled down. Then press the
bubble button and confirm that the
bubble function is working again.
Dirty filter cartridge &
Clean the filter cover and replace the
cover.
filter cartridge
Fill the water till it stays between the
Water level too low.
MIN and MAX water line
Check and clean filtration inlet and outlet
The SPA
regularly. Unscrew the filter cartridge and
is too
put your hand in front of the filter housing
noisy
to feel the water flow.
(over
If there is water flow and the filter pump
Filtration inlet and/or
85dB)
making sound, the filtration inlet and outlet
outlet dogged.
is clogged. Disassemble the filter pump
and remove the debris.
If there is no water flow and the filter pump
does not make any sound, the filter pump
is dead. Please contact our customer
service.
Insufficient filtering time
Increase the filtering time
Dirty filter cartridge &
Clean the filter cover and replace the
cover.
filter cartridge
Poor or insufficient
Follow the instructions of the chemicals
water treatment
manufacturer to maintenance the water.
The water
Check and clean filtration inlet and outlet
is not
regularly. Unscrew
clean
the filter cartridge and put your hand in
front of the filter
housing to feel the water flow.
Filtration inlet and/or
If there is water flow and the filter pump
outlet clogged.
making sound, the
filtration inlet and outlet is clogged.
Disassemble the filter
pump and remove the debris.
If there is no water flow and the filter
pump does not make any sound, the filter
pump is dead. Please contact our
customer service.
31
Publicité
