Publicité
Les langues disponibles
Les langues disponibles
WARNING
The SPA must be used with the 2 filters to prevent hairs or other
small debris from entering the chassis, to damage the circulation
function and influence the service life of spa.
STEP 7 - Fill the Spa with water.
It is highly recommended to fill the spa with tap water to minimize
the influence of unwanted content, such as minerals. DO NOT use
rainwater, surface water, seawater.
• Fill the spar sufficiently(water line between the MIN and MAX mark
on the inside spa wall).
• DO NOT pour water with a temperature higher than 104℉(40℃)
into the spa directly.
• Do not add bath oil or bath salt to the spa water.
WARNING
DO NOT operate the spa if water is lower than the minimum
waterline.
DO NOT allow the water in the spa to freeze. Do not turn on the spa
when the water is frozen.
STEP 8 - Secure the spa cover.
Place the spa air bladder into the spa tub. Then attach the Spa
Cover(D) and buckle up. Lock with the provided Key(Q).
18
WARNING
• Attach and lock spa cover after each use.
• Inspect the spa cover regularly for leaks, premature wear and tear,
damage, or signs of deterioration. Never use a worn or damaged
cover: it will not provide the level of protection required to prevent
unsupervised access to the spa by a child.
• Always open the spa' s cover before activating its jets.
• Stay off cover – will not support weight.
• Remove cover completely before entry of bathers entrapment
possible.
STEP 9 - Use the SPA.
Plug the power cord into a grounded electrical socket and press the
RESET button on the GFCI plug. The Control Base is ready for use.
Set the desired water temperature and press the HEATER button to
start heating, see "Spa Control Panel" operation section.
WARNING
The GFCI must be tested before each use.
1. Plug the power cord into a grounded electrical socket.
2. Press the TEST button on the GFCI. The GFCI indicator should
turn off and the electrical equipment should shut down.
3. Press the RESET button on the GFCI. The indicator turns red and
the spa is ready for use.
DO NOT use the spa if the GFCI does not function properly.
Disconnect the power cord and contact a qualified electrician to
correct the fault.
DO NOT bypass the GFCI. There are no serviceable parts inside the
GFCI.
DO NOT unplug by pulling the cord. The GFCI plug might be
damaged.
19
Publicité
